Nanoseismic monitoring of gravity-induced slope instabilities for the risk management of an aqueduct infrastructure in Central Apennines (Italy)

A monitoring system is operative in the Peschiera Springs slope (Central Apennines, Italy) to mitigate the landslide risk related to the hosted main drainage plant of Rome aqueducts by providing alert warning. Such a strategy allows to avoid out-of-service episodes so reducing extra-costs of water distribution management. The Peschiera Springs slope is involved in a rock mass creep characterized by an average steady strain rate of 1 mm year-1 and responsible for several landforms including sinkholes, subvertical scarps and trenches. Moreover, an average aquifer discharge of 19 m3 s-1 causes an intense limestone dissolution concentrated in correspondence with release bands and discontinuities that dislodge the jointed rock mass. Since 2008, an accelerometric network has been operating within the slope; about 1300 microseismic local events were recorded up to now, distinguished in failures and collapses. A control index, based on frequency of occurrence and cumulative energy of the recorded microseismic events was defined to provide three levels of alert. In 2013, a temporary nanoseismic Seismic Navigation System (SNS) array was installed inside a tunnel of the drainage plant to integrate the pre-existent seismic monitoring system. This array allowed to record 37 microseismic events, which locations are in good agreement with the evolutionary geological model of the ongoing gravitational slope deformation. In 2014, a permanent nanoseismic SNS array was installed in the plant and allowed to record several sequences of underground collapses including more than 500 events. The nanoseismic monitoring system is allowing to: (1) increase the detection level of the monitoring system; (2) locate hypocentres of the events; and (3) detect precursors of the strongest events.