Numerical analysis of compressed concrete columns confined with CFRP: Microplane-based approach

This paper presents the results of numerical studies carried out on concrete columns confined by Carbon Fiber Reinforced Polymer (CFRP) and loaded in uni-axial compression. A numerical simulation of confined columns experimentally tested by [1] is performed for relatively small concrete specimens of constant size but with different cross-section corner radius. The experimental results, reported in terms of axial stress–strain relationships and failure modes, constitute a useful database for the calibration of numerical models. These results clearly demonstrate that CFRP confinement is much less effective in square than in circular cross-sections. Therefore, the influence of the corner radius on the non-uniform stress distribution due to confinement, is numerically investigated using the proposed microplane-based model that takes into account the effect of multi-axial stress states in concrete. The experimental results are used to calibrate and verify the prediction capability of a three-dimensional finite element code (3D FE) that is based on the microplane constitutive law for concrete [2]. In the finite element model carbon fibers are modelled using nonlinear truss elements, while epoxy resin as well as concrete are modelled using microplane-based constitutive law and 3D finite elements. Given that experimental results for unconfined and confined configuration are available for each specimen, the 3D FE concrete model has been preliminarily calibrated on unconfined concrete specimens and then used in the analysis of a confined specimen. It is demonstrated that numerical models can predict behavior of confined concrete columns from the experimental investigations, confirming the predictability of the numerical microplane-based approach used.