Data on synthetic fault gouge previously collected by Richardson and Marone [1999] were compared with the predictions of a unified theory for rate- and state-dependent friction compiled by Sleep [1997]. The theory treats the gouge as a continuum one-dimensional fluid sheared between parallel plates. It is predicted that the strain rate localized into a shear band of width called Wss during steady state sliding from the nominal width of the gouge zone Wnom. The critical displacement during velocity stepping tests is predicted to be Wssεint, where εint is the critical strain, an intrinsic material property. It is predicted that the strain rate for renewed sliding after holds delocalizes to a width Wnew which is greater than Wss and for long holds approaches the full gouge zone width Wnom. The displacement for recovery of the shear traction to its steady state value is predicted to be Wnewεint, which for long holds is much greater than the critical displacement obtained by velocity stepping. Only the macroscopic effects of this process could be studied using the laboratory data in hand. Compaction during the hold and the difference between peak shear traction upon restart and the steady state shear traction during sliding (healing) were measured. To simulate more complex normal traction variations on real faults, the normal traction was varied sinusoidally about its previous value during some holds. The theory reasonably predicts the observed relationship between healing and compaction and healing versus hold time. It predicts the slip needed for recovery of shear traction following holds but poorly predicts the shear traction versus time during recovery. We attribute this failure to the fact that the laboratory gouge is a heterogeneous three-dimensional substance. Qualitatively, the delocalized width Wnew varies with position within the gouge plane, and slip is required for localized shear to organize in three dimensions. As strain rate was not observed as a function or time and position within the gouge, other explanations for the observed long recovery times following holds remain viable, including consolidation strengthening. Copyright 2000 by the American Geophysical Union.

Physics of friction and strain rate localization in synthetic fault gouge / Sleep, N. H.; Richardson, E.; Marone, C. J.. - In: JOURNAL OF GEOPHYSICAL RESEARCH. - ISSN 2156-2202. - 105:11(2000), pp. 25875-25890. [10.1029/2000jb900288]

Physics of friction and strain rate localization in synthetic fault gouge

Marone C. J.
Membro del Collaboration Group
2000

Abstract

Data on synthetic fault gouge previously collected by Richardson and Marone [1999] were compared with the predictions of a unified theory for rate- and state-dependent friction compiled by Sleep [1997]. The theory treats the gouge as a continuum one-dimensional fluid sheared between parallel plates. It is predicted that the strain rate localized into a shear band of width called Wss during steady state sliding from the nominal width of the gouge zone Wnom. The critical displacement during velocity stepping tests is predicted to be Wssεint, where εint is the critical strain, an intrinsic material property. It is predicted that the strain rate for renewed sliding after holds delocalizes to a width Wnew which is greater than Wss and for long holds approaches the full gouge zone width Wnom. The displacement for recovery of the shear traction to its steady state value is predicted to be Wnewεint, which for long holds is much greater than the critical displacement obtained by velocity stepping. Only the macroscopic effects of this process could be studied using the laboratory data in hand. Compaction during the hold and the difference between peak shear traction upon restart and the steady state shear traction during sliding (healing) were measured. To simulate more complex normal traction variations on real faults, the normal traction was varied sinusoidally about its previous value during some holds. The theory reasonably predicts the observed relationship between healing and compaction and healing versus hold time. It predicts the slip needed for recovery of shear traction following holds but poorly predicts the shear traction versus time during recovery. We attribute this failure to the fact that the laboratory gouge is a heterogeneous three-dimensional substance. Qualitatively, the delocalized width Wnew varies with position within the gouge plane, and slip is required for localized shear to organize in three dimensions. As strain rate was not observed as a function or time and position within the gouge, other explanations for the observed long recovery times following holds remain viable, including consolidation strengthening. Copyright 2000 by the American Geophysical Union.
2000
friction, earthquakes
01 Pubblicazione su rivista::01a Articolo in rivista
Physics of friction and strain rate localization in synthetic fault gouge / Sleep, N. H.; Richardson, E.; Marone, C. J.. - In: JOURNAL OF GEOPHYSICAL RESEARCH. - ISSN 2156-2202. - 105:11(2000), pp. 25875-25890. [10.1029/2000jb900288]
File allegati a questo prodotto
Non ci sono file associati a questo prodotto.

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11573/1688265
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 60
  • ???jsp.display-item.citation.isi??? ND
social impact